Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair Before & After in Bedford, TX
We could tell you we do clean work, but a photo record makes the point in about three seconds. Every gate we touch leaves with the same thing attached to the job file: pictures of what it looked like when we pulled up, what we found underneath the covers, and what it looks like when we’re done. Here are a few recent transformations from around Bedford, from sagging driveway gates to openers that had quietly given up.
Recent Transformations
Sagging Driveway Gate, Bedford’s Oak Forest Area
The gate was dragging a two-inch groove into the driveway because the hinge post had pulled off plumb over about ten years of Texas clay movement. We cut the post free, set it back in a deeper concrete footing, and re-hung the leaf so it swung with a half-inch clearance. The photo log we left showed the post level reading before and after, plus the new hardware in place.
Chain-Drive Opener Failure on a Harvey Street Property
The motor ran, but the chain had stripped enough teeth on the drive sprocket that the gate wasn’t going anywhere. We replaced the sprocket and chain, reset the open and close limits, and photographed the new limit positions against the old ones. It’s the kind of repair that takes an hour, but only if you don’t try to force the motor to do work it can’t do anymore.
Keypad Not Reading Cards on a Light Commercial Gate
A Bedford office complex had a keypad that would beep but never actually send a signal to the board. We traced it to a corroded connection inside the pedestal, cleaned and re-terminated the wiring, and ran a test with three different cards and a code. The before-and-after photos show the green terminal block reading corrosion, followed by the clean block and a gate mid-open on command.
Welded Patch on a Twisted Iron Gate Leaf
The bottom corner weld had cracked and the gate was twisting enough to bind against the latch post. We ground out the failed weld, squared the frame, and re-welded it with a gusset so the same spot doesn’t become the next weak point. The after photo shows the gate hanging straight with no twist, and the repair is invisible unless you know where to look.
Photon Beam Misalignment Causing Gate Reversals
A homeowner called because the gate would start closing, then jump back open every single time. The photo-eyes, the infrared beam that stops the gate when something crosses the path, had been knocked about two inches out of line and were talking to each other’s housings instead of their lenses. We realigned them, fastened the brackets so a stiff wind wouldn’t undo the work, and watched the gate close ten times in a row without a reversal.
Want Results Like These?
Every one of these jobs started the same way: a live person answered the phone, we set a time, and we showed up with a written price before any work began. If your gate is dragging, dead, or just acting strange, call (817) 572-8590. You’ll get the same photo record of what we found and what we did.
Written by Adrian Vance, Owner at Vance Gate Repair Bedford, serving Bedford since 2014.