Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in Dallas, TX
Gate access control in Dallas usually means one of three jobs: a keypad that stopped accepting codes, a phone-entry system that quit ringing the house, or an operator that opens for every vehicle except the owner’s. The work is fast to diagnose, and most access-control repairs are finished the same day for $95-$380 depending on what failed. Call (817) 572-8590 if a gate is locked open or won’t open at all. Vance Gate Repair writes the price down before anyone touches a tool, and every job leaves with a photo record of what was found and what was set.
Why Dallas Homes Are Different
Dallas sits on Blackland Prairie clay that swells in spring and contracts through summer drought. Gate posts heave and lean by inches, which binds hinges and throws operator travel limits out of alignment. In Preston Hollow and Devonshire, ornamental steel driveway gates installed in the 1980s and 1990s are now reaching the 20-30 year mark for operators, hinges, and access-control wiring. Summers over 100°F warp powder-coated frames and push swing gates out of latch alignment. The hard freezes, most notably February 2021, crack PVC conduit and snap latches made brittle by cold. When a Dallas gate sags on one side, the near post has usually heaved two or three inches out of plumb, and resetting limits without re-plumbing the post just delays the callback.
Our Main Dallas Services
Gate Repair in Dallas
Most repair calls are hinge bind, a dead operator, a snapped chain, or a gate that reversed into a car. On Dallas clay, we check post plumb first because a leaning post makes every other repair temporary. Gate Repair in Dallas covers the full diagnostic and fix, with a written price before work starts.
Gate Installation in Dallas
New gates in Dallas need footings set for clay movement, not just a concrete pour. We build for thermal expansion and post heave from day one, and we document the whole job in photos before we leave. Gate Installation in Dallas covers site prep, fabrication, and automation.
Gate Motor & Opener in Dallas
Operators fail from heat, power surges, or limits that were never reset after a post shifted. We service nine automation brands and replace swing, slide, or barrier operators without steering you toward a new gate. Gate Motor & Opener in Dallas covers the diagnosis, replacement, and setup.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
BeforeAfterGate Access Control in Dallas
Gate access control in Dallas fails most often after storms, power blips, or when original installers left codes in a keypad that no one wrote down. The operator may be fine; the entry system just stopped telling it to open. We service every common system on the market, from simple Ghost Controls keypads to full phone-entry and video intercom setups. Gate Access Control covers the hardware, wiring, and programming.
Keypad Entry
Signs you need it
Codes that worked last week now flash red, or every code works except the one you gave the house cleaner.
What it costs in Dallas
Keypad replacement or reprogramming in Dallas runs $95-$280, depending on whether the keypad is hardwired or wireless and whether the control board survived.
How we do it
We test voltage at the keypad, check the control board input, replace or reprogram, then photograph the new code list and leave you a written record.
Phone Entry
Signs you need it
Guests call from the gate and hear silence, or the house phone rings once and the gate never opens.
What it costs in Dallas
Phone-entry repair in Dallas typically lands between $180-$380, depending on whether it’s a wiring splice, a relay, or the phone unit itself.
How we do it
We trace the line from gate to house, isolate the relay or phone unit, replace the failed part, and test with a live call while you watch.
What Gate Access Control Costs in Dallas
| Item | Typical range in Dallas |
|---|---|
| Keypad replacement or reprogramming | $95-$280 |
| Phone entry repair | $180-$380 |
| Card reader or video intercom repair | $220-$550 |
Can you fix a gate keypad the same day in Dallas?
Yes. Keypad repairs are usually same-day because the parts are common and stocked locally. Call (817) 572-8590 with the keypad brand if you can read it, and we’ll bring the right part on the first trip.
Will a power surge damage gate access controls?
Yes. Dallas storms knock out keypads, phone-entry boards, and card readers regularly. We test the surge point before replacing anything so the new part isn’t destroyed by the same fault. Estimates are free; call (817) 572-8590.
Gate Parts & Welding in Dallas
Gate parts and welding in Dallas usually means a hinge worn egg-shaped, a post heaved out of plumb, or a weld that cracked after a decade of thermal cycling. Clay movement makes post trouble the most common call we run. Gate Parts & Welding covers replacement parts, steel fabrication, and repair welds on ornamental and heavy gates.
Hinge Replacement
Signs you need it
The gate drags at the latch, the hinge pin is visibly worn, or grease only quiets it for a week.
What it costs in Dallas
Hinge replacement runs $120-$450 in Dallas, depending on hinge weight, whether the post must be re-plumbed, and access for welding.
How we do it
We unload the gate, cut or unbolt the old hinge, weld the new one, re-hang, and photograph the finished weld.
Post Replacement
Signs you need it
The post leans more than an inch, the gate won’t latch, or fresh concrete around the base cracked within a year.
What it costs in Dallas
Post replacement in Dallas runs $350-$900, depending on depth, concrete volume, and whether the gate must be reframed after the post is set.
How we do it
We set the new post below the clay movement line, brace it plumb, pour, and return after cure to re-hang and set travel limits.
What Gate Parts & Welding Costs in Dallas
| Item | Typical range in Dallas |
|---|---|
| Hinge replacement | $120-$450 |
| Post replacement | $350-$900 |
| Custom welding or rail repair | $90-$300 |
Why do gate posts heave in Dallas?
Blackland Prairie clay shrinks and swells with moisture, pushing shallow posts out of the ground. Replacing a post without setting it deeper just repeats the problem. Call (817) 572-8590 and we’ll assess the soil depth.
Can you weld ornamental iron so the repair doesn’t show?
Yes. We grind, match the profile, and powder-coat or paint to blend with the original finish. A photograph of the finished weld is part of every job record. Call (817) 572-8590 for a written price.
Brands We Service in Dallas
We service DoorKing, Elite, Ghost Controls, and Mighty Mule among the nine major automation brands we work on. Parts for those four are stocked in our service vehicles or available same-day from Dallas suppliers. Our brands page lists what we carry and what we can order.
Pricing for Gate Repair in Dallas, TX
| Service | Typical range in Dallas |
|---|---|
| Gate access control repair | $95-$550 |
| Keypad replacement | $95-$280 |
| Phone entry repair | $180-$380 |
| Card reader or video intercom repair | $220-$550 |
| Hinge replacement | $120-$450 |
| Post replacement | $350-$900 |
| Custom welding or rail repair | $90-$300 |
| Gate operator diagnosis and repair | $150-$600 |
Dallas prices push higher when clay movement has shifted a post or when a gate needs reframing after years of heat warping forced panels out of square. Every price is written and agreed before work starts, so the number you hear is the number you pay.
Neighborhoods We Serve in Dallas
Our crews work across Dallas daily, from Preston Hollow and Devonshire to Midway Hollow and far North Dallas. Most calls are reached the same day depending on the time of the call and the part needed.
- Preston Hollow
- Devonshire
- Midway Hollow
- Far North Dallas
- Lake Highlands
Service Area - Cities Near Dallas
We serve Dallas and the surrounding metro, including Irving, TX, Grand Prairie, TX, Coppell, TX, and Euless, TX. The same written-price policy and photo-record documentation apply on every job, in every city.
Serving Dallas, TX - Our Local Coverage Area
We’re based in the Dallas area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Dallas
Most Dallas calls are reached the same day when we’re called before early afternoon. Emergency gate repairs, like a gate stuck open or a failed motor on a shared driveway, get priority routing. Call (817) 572-8590 and a live person will give you a real arrival window.
Most repairs and part replacements don’t need a permit. New gate installations or major post work can, depending on the property and HOA rules. We tell you in writing if your job needs approval before any work starts. Call (817) 572-8590 to find out.
Yes. Many Preston Hollow and gated-community HOAs require written notices, specific gate styles, or documented work records. We provide the photo log and written summary most HOAs ask for. Call (817) 572-8590 and tell us what your HOA requires; we’ll handle the rest.
For gate repair, access control, or welding work in Dallas, call (817) 572-8590. You’ll get a live person, a written price before any work starts, and a documented record of everything we did before we leave.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Dallas Customers Say
"Gate had been dragging for a year. They photographed the bent hinge post, explained why the operator kept faulting, and gave me a fixed price to correct both."
- Terrence B."Our gate was hit by a delivery truck. They came out, documented the damage properly for the insurer, and the claim went through without an argument."
- Camille R."They installed the opener and left me a diagram of the wiring and the limit settings. When I needed a second remote programmed I could do it myself."
- Nadine C.